Infortrend S12F-G1842 - Installing the BBU (Type II)

EonStor / EonStor DS S12/S16/S24 Series
102
Installing the BBU (Type II)
NOTE
For type II controller FBMs, please contact your vendor.
Remove the four screws and the top cover from the controller shown below.
Install the BBU to the top cover by securing the three screws.
Insert the back end of the BBU (1) onto the controller, connect the BBU power cable
(2) and secure the top cover with the BBU using the four screws (3) shown below.
1
2
3
3
66