ESD Precautions
ESD Precautions
Handle the modules by their retention screws, ejector levers, or the
module’s metal frame/faceplate only. Avoid touching the PCB boards or
connector pins.
Use a grounded wrist strap and an anti-static work pad to discharge
static electricity when installing or operating the enclosure.
Avoid dust, debris, carpets, plastic, vinyl, and styrofoam in your work
area.
Do not remove any module or component from its anti-static bag before
installation takes place.
Drives must not be stacked on top of each other without their protective
drive trays. Even when drives are fixed in the drive trays, contacting the
exposed PCB or rear-side interface may damage the drives.
To Next Page
Loading...
