Ingenico AXIUM DX8000-BASE-W1 - Base Operating Modes

To Next Page

To Previous Page

AXIUM DX8000-BASE-W1

07/25

Banks and Acquirers International Holding SAS

4.7 Base Operating Modes

4.7.3 WiFi Repeater Mode

4.7.1 Gateway / Router Mode – Default Operating Mode

Local router distributes a corporate IP address to the Base Station Ethernet port.

Base distributes IP addresses to DX8ooo devices via internal DHCP server.

DX8oooBase and devices are on private network segment (e.g. 192.168.47.X).

Only the Base Station IP address is visible to and addressable by the network.

All of the device private IP addresses are masked from the network by NAT.

4.7.2 Bridge Mode - (Also known as Access Point Mode)

Router distributes corporate IP network addresses to the bases and DX8ooo devices.

Base and devices are directly connected to local router and on the same network

segment.

Base DHCP server is turned off and NAT is not used.

All device IP and MAC Addresses are visible to and addressable by the network.

Designed to expand wireless coverage, by connecting two bases together by Wifi.

For example, DX8000 is too far away to connect Base A.

Put Base B between Base A and DX8000 & Set Base B repeat the Base A.

DX8000 can connect to internet via Base B.

Does not operate with a Mesh network.