Moneris Core® Desk/5000 Terminal: Setting up Your Hardware 5
Install the paper roll
1. Lift the printer latch up, and then pull back to open the lid
and expose the paper well.
2. Insert the paper roll into the paper well with the loose end
unrolling from the top of the roll toward the back of the
terminal.
Note: If the paper is installed backward, your printouts will be
blank.
3. Unroll enough paper to extend at least one inch (2.5 cm)
over the top of the lid.
4. Close the lid, and press down to snap it back into place so
that the extended paper is pressed securely against the
closed lid and the faceplate.
Note: The paper should unroll back over the top of the
printer, not unroll over the faceplate.
Note: To advance the paper from the printer when the lid is
closed, you must press and hold down the paper feed key
when the terminal is powered on. DO NOT attempt to
manually advance the paper by pulling it as this will damage
the printer.
5. Your hardware setup is complete. To set up your software, refer to the Moneris Core® Desk/5000 Setting up
Your Software guide available at moneris.com/support-desk5000.
To Next Page
Loading...
