4
Register the Ingenico Payment Device
Important: The register must be connected to the same network as the payment
device.
1. On payment device, the Welcome Store User screen will display. Press the
GREEN keypad button to continue.
2. Enter the Store ID and press the GREEN confirm button on the keypad.
a. The Store ID may be found on the Store Place Portal of the store for
which the device is being registered.
3. Enter the Zip Code of the store for which the device is being registered and
press the GREEN confirm button on the keypad.
4. Enter the Lane/Register Number and press the GREEN confirm button on the
keypad.
a. This value is the number of the POS Register the payment device will
connect to (i.e., 1, 2, 3, etc.).
5. The payment device connects to the gateway and registers itself under the
Store ID entered in Step #2.
6. If the screen below is encountered, select “Yes” to overwrite the existing
terminal with the new payment device.
7. After successful registration, the CCT will reboot.
To Next Page
Loading...
