Ingersoll-Rand 1 Series User Manual (English)

Other manuals for Ingersoll-Rand 1 Series

Operation And Maintenance Manual36 pages

Product Information60 pages

Questions and Answers:

W
Whitney BryantAug 12, 2025
How to fix loss of power in my Ingersoll-Rand 1 Series Drill?
- D
  Debbie PerezAug 12, 2025
  Loss of power in your Ingersoll-Rand Drill can stem from several causes. Start by checking the air supply to ensure the air pressure is at 90 psig (6.2 bar/620 kPa) at the inlet for optimal performance. Also, inspect and clean the air strainer or inlet screen using a suitable cleaning solution, replacing it if cleaning isn't effective. A clogged muffler or exhaust silencer could also be the culprit; clean the muffler element or replace it if necessary. Other potential issues include worn or broken vanes (replace the complete set), a damaged rear end plate gasket (install a new one), a worn or broken cylinder (replace if cracked or scored), or improper lubrication/dirt build-up (clean and lubricate the motor unit parts).
E
erica35Aug 19, 2025
What to do if my Ingersoll-Rand 1 Series's gear case gets hot?
- S
  Stephanie MillerSep 12, 2025
  If the gear case of your Ingersoll-Rand Drill is getting hot, it could be due to excessive grease or worn/damaged parts. Begin by cleaning and inspecting the gear case and gearing parts, then lubricate as instructed. If the issue persists, clean and inspect the gear case and gearing again, replacing any worn or broken components.
J
Jessica MorganAug 27, 2025
Why is my Ingersoll-Rand 1 Series throttle valve leaking?
- G
  Gabriel VasquezAug 27, 2025
  A leaky throttle valve in your Ingersoll-Rand Drill may be due to a worn throttle valve and/or throttle valve seat, in which case you should install a new throttle valve and/or a throttle valve seat. Another cause could be dirt accumulation on the throttle valve and/or throttle valve seat. To resolve this, pour about 3 cc of a clean, suitable cleaning solution into the air inlet and operate the tool for about 30 seconds. Immediately after, pour 3 cc of the recommended oil into the air inlet and operate the tool for 30 seconds to lubricate all the cleaned parts.
S
Sarah WilliamsSep 3, 2025
What to do if the angle head of my Ingersoll-Rand 1 Series gets hot?
- J
  Julie KlineSep 3, 2025
  If the angle head of your Ingersoll-Rand Drill is getting hot, the problem might be excessive or inadequate grease, or worn/damaged parts. First, clean and inspect the angle head and gearing parts and lubricate as instructed. If the issue continues, inject 0.5 to 1.5 cc of the recommended grease into the grease fitting. Finally, clean and inspect the angle head and gearing; if the bevel gear and/or bevel pinion is worn or broken, replace both parts as they are a matched set.