Ingersoll-Rand 302 SERIES - Parameter Setup and Menu Modes

21
Status screen I:
This read-out state is standard after start-up or
initialization. Use [INFO] to obtain information about the
measurement links to the displayed operating variables
(1.1, 1.2, 1.3, 2 and 3). See the operating variables
shown in the screen in this illustration.
1.1
1,2
2
3 1.3
Status screen II:
See the operating variables (1.1, 1.2, 1.3 and 2) shown in
the screen in this illustration. In the example, Speed,
Motor current, Motor power and Frequency are selected
as variables in the first and second.
1.1
1,2
1.3
2
Status screen III:
This state displays the event and action of the Smart
Logic Control. For further information, see section Smart
Logic Control.
Parameter Set-Up
The Ingersoll Rand 302 Series (VFD) can be used for
practically all assignments, which is why the number of
parameters is quite large. The series offers a choice
between two programming modes - a Main Menu and a
Quick Menu mode.
The former provides access to all parameters. The latter
takes the user through a few parameters making it
possible to start operating the frequency converter.
Regardless of the mode of programming, you can
change a parameter both in the Main Menu mode and in
the Quick Menu mode.