Ingersoll-Rand 302 SERIES - Parameter Adjustment and Data Change

23
Main Menu Mode
Start the Main Menu mode by pressing the [Main Menu]
key. The read-out shown to the right appears on the
display. The middle and bottom sections on the display
show a list of parameter groups which can be chosen by
toggling the up and down buttons.
Each parameter has a name and number which remain
the same regardless of the programming mode. In the
Main Menu mode, the parameters are divided into
groups. The first digit of the parameter number (from the
left) indicates the parameter group number.
All parameters can be changed in the Main Menu.
However, depending on the choice of configuration (par.
1-00), some parameters can be "missing". E.g. open loop
hides all the PID parameters, and other enabled options
make more parameter groups visible.
Parameter Selection
In the Main menu mode, the parameters are divided into
groups. You select a parameter group by means of the
navigation keys. The following parameter groups are
accessible:
Group #
Parameter group: Group
0
Operation/Display
1
Load/Motor
2
Brakes
3
References/Ramps
4
Limits/Warnings
5
Digital In/Out
6
Analog In/Out
7
Controls
8
Comm. and Options
9
Profibus
10
CAN Fieldbus
11 Reserved Com. 1
12
Reserved Com. 2
13
Smart Logic
14 Special Functions
15
Drive Information
16
Data Readouts
17 Motor Feedb. Option
After selecting a parameter group, choose a parameter
by means of the navigation keys. The middle section on
the display shows the parameter number and name as
well as the selected parameter value.
Changing Data
The procedure for changing data is the same whether
you select a parameter in the Quick menu or the Main
menu mode. Press [OK] to change the selected
parameter. The procedure for changing data depends on
whether the selected parameter represents a numerical
data value or a text value.
Changing a Text Value
If the selected parameter is a text value, change the text
value by means of the [
▴] [▾] navigation keys. The up
key increases the value, and the down key decreases the
value. Place the cursor on the value you want to save
and press [OK].
Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric data value,
change the chosen data value by means of the [
◂] [▸]
navigation keys as well as the [
▴] [▾] navigation keys.
Use the [◂] [▸] navigation keys to move the cursor
horizontally
Use the [▴] [▾] navigation keys to change
the data value. The up key enlarges the data value, and
the down key reduces the data value. Place the cursor on
the value you want to save and press [OK].