Ingersoll-Rand INSIGHTqc - Page 13

Torque result is 'Low Torque'
failure, if the value of torque is
below the minimum torque limit.
Otherwise, the Torque result is a
Pass.
Angle Result
Angle result is 'High Angle' failure,
if the value of angle exceeds the
maximum angle limit. Angle result
is 'Low Angle' failure, if the value
of angle is below the minimum
angle limit. Otherwise, the Angle
result is a Pass.
Measured/Peak
Angle (°)
Maximum value of angle achieved
during fastening.
Reason for Shutdown
Indicates the cause for cycle abort
or termination.
Spindle Cycle
Number
Incremental number of fastenings
performed by the connected tool.
This is used to uniquely identify
fastening results for a particular
fastener.
Job Name
Indicates the name given for the
user defined job.
Pset Name
Indicates the name given for the
user defined Pset.
Barcode
If enabled, it displays barcode
scanned from a scanner.
Operator Name
Indicates the name of the operator
who performed the fastening.
If available, user can select
on the result page, to view Trace related information. To get
additional information on a specific result record, select
. A pop-up with additional information
will be displayed. To refresh the job results, select
.
Exporting to CSV
To download job results in CSV format, select
Export to CSV. The job results displayed on the
screen will be downloaded. NOTE: User working on a local display must connect a USB pen drive
to the controller before downloading.