Close
Go
Back
Tool
Diagnostics
This
screen
provides
real
time
information
about
the
tool
connected
to
the
Fastening
Controller.
Tool Information section gives information related to Tool Model Number and Tool Serial Number
along
with
values
for
the
listed
parameters.
Tool
Fault
section
gives
information
related
to
errors
along
with
date
and
time
of
the
occurrence.
Select
Enter
diagnostics
to
start
the
tool
diagnostics.
Select
to
view
Tool
Information
and
Tool
Fault
contents.
Tool
Information
Parameters
displayed
on
the
screen
are
described
as
follows:
Parameter Description
Tool
Model
Number
Model number of the connected
tool.
Tool
Serial
Number
Serial number of the connected
tool.
Tool Max Torque
(Nm)
Maximum allowable Torque for
the connected tool.
Tool Max Speed
(RPM)
Displays maximum allowable
speed of the motor.
Tool
Max
Temperature
(°C)
Maximum allowable temperature
of the tool motor before alarm
activation.
Tool Cycle Count
Total number of cycles that the
tool has run. This is for the
lifetime of the tool.
Warranty Start Date
(mm/dd/yy)
Start date of the warranty for the
tool.
Tool
Fault
The
information
shown
is
related
to
tool
faults.
Parameters
displayed
on
the
screen
are
described
as
follows:
Parameter Description
Date and time of the fault reported.
To Next Page
Loading...
