Ingersoll-Rand INSIGHTqc - Pset and Step Configuration

Close
Go Back
Pset
This screen allows the user to create, edit or delete Psets.
Parameters displayed on the Pset screen are described as follows:
Parameter Description
ID Indicates the Pset ID.
Pset
Indicates the name given to
identify the Pset.
To edit the Pset, select the Pset.
Delete
Select to delete the created Pset.
On deleting the Pset, associated
jobs will be deleted.
Create Pset
Do the following to create a new Pset:
At the Pset List screen, select Create Pset.1.
The Create Pset screen will be displayed.
At Pset Name, select
to view the contents.2.
In the Name field, enter a name for this Pset.3.
In the Units field, select a unit type for measurement from the drop down list.4.
To define Step type, proceed to Create Step. Else, proceed to Step 6.5.
To define Pset settings, proceed to Advance Pset Settings . Else, proceed to Step 7.6.
Select Save.7.
Advance Pset Settings
Do the following to define advance Pset settings:
At the Create Pset screen, select Advance Pset Settings .
The Advance Pset screen will be displayed.
1.
At General Parameters, select
to view the contents:2.
Under Tool Motor Direction, select one:a.