Ingersoll-Rand INSIGHTqc - Create Step; Advance Step Settings

At Tubenut Parameters, select to view the contents:4.
In the Reverse Speed (RPM) field, enter a value for the maximum speed at which the tool
will run in reverse direction.
a.
In the Reverse Threshold (%) field, enter a value (percentage of max torque) at which the
tubenut tool will stop while reversing to the home position.
b.
At Total angle, select
to view the contents:5.
If enabled, do as follows:a.
In the Low Limit field, enter a value for the minimum acceptable limit.x
In the High Limit field, enter a value for the maximum acceptable limit.x
To save the advance Pset settings, select Ok.6.
Create Step
Do the following to create a new step:
At Torque, select
to view the contents.1.
In the Step Type field, select one from the drop down list:2.
Torque : Force applied to a fastener.x
Angle : Angle in degrees that a fastener will turn past the torque threshold point.x
Prevailing Torque : Applied torque will not provide clamp load prior to or in lieu of a
final fastening step.
x
NOTE : The Prevailing Torque step must be followed by either
a torque step or an
angle step and advanced step settings are required.
If Torque is selected, in the Target (N m) field, enter the target value. Else, proceed to Step
4.
3.
If Angle is selected, do the following (else, proceed to Step 5):4.
In the Target (°) field, enter the target value. x
In the Torque High Limit field, enter a value for the maximum allowable torque.x
To
define step settings, proceed to Advance Step Settings . Else, proceed to Step 6. 5.
Select Save.6.
Advance Step Settings
To view Advance Step screen, select
Advance Step Settings. These step settings are
applicable for the following step types:
Torquex