Close
Go
Back
Fieldbus
Settings
The
screen
allows
setting
I/O
and
controls
for
industrial
fieldbus.
Do
the
following
to
enable
fieldbus:
From
the
Type
field,
select
from
the
following:1.
Nonex
Ethernet
Ipx
Profinetx
To
enable
fieldbus
master
to
control
a
tool
in
machine
mount
mode,
select
within
the
Enable
Bus
Controls
System
field
to
show
indicator
in
ON
position.
2.
To
enable
barcode
data
from
fieldbus,
select
Enable
Barcode
Input.3.
For setting
input assignment, do as follows:4.
Select Input Assignment.
The
Fieldbus
Assignment
screen
will
be
displayed.
a.
Under Input Bit Assignment, select to view Byte 0, Byte 1 or Byte 2 contents. b.
For
Bit
0
-
7,
do
as
follows:c.
From Select Data fields, select a behavior to assign to the bit. On completion, select
OK.
x
From
Polarity
fields,
select
from
the
following:x
Normally
Openx
Normally
Closex
Select Ok.d.
For
setting
output
assignment,
do
as
follows:5.
Select
Output
Assignment.
The
Fieldbus
Assignment
screen
will
be
displayed.
a.
Under
Output
Bit
Assignment,
select
to
view
Byte
0,
Byte
1
or
Byte
2
contents.b.
For Bit 0 - 7, do as follows:c.
From
Select
Data
fields,
select
a
behavior
to
assign
to
the
bit.
On
completion,
select
OK.
x
To Next Page
Loading...
