Ingersoll-Rand INSIGHTqc - Digital IO; Adding Modules

Close
Go Back
Digital IO
This screen allows the user to add, edit or delete Input / Output devices.
Adding Modules
Do the following to add I/O modules:
Select Add Module.1.
From the ADD Device IO field, select a device type from the drop down list:2.
QLight (0x4)x
Light Tree (0x3)x
Socket Tray (4x4)x
DIO Box (4x4)x
DIO Box (8x8)x
From the Ports Available field, select a port to establish physical connection.3.
NOTE
: Make sure to select the port to which the I/O device is connected.
To set IO Assignment, do as follows:4.
If QLight (0x4) or Light Tree(0x3) is selected from ADD Device IO field, select IO
Assignment to view Output Assignment contents.
a.
To edit the Output Assignment contents, select Edit.x
For point 0 - 3, do as follows: x
From the Behaviour fields, select from a list of behaviours
and then
select Apply .
x
From the Polarity fields, select from the following:x
Normally Openx
Normally Closex
In the Timeout (Sec.) fields, enter the duration for which the output
needs to be active.
x
For activating LED notification, select Blink.x
Select Ok.x
If any other device is selected from ADD Device IO field, select IO Assignment to view b.