Close
Go
Back
Job
This
screen
allows
the
user
to
create,
edit,
or
delete
jobs.
Parameters
displayed
on
the
job
screen
are
described
as
follows:
Parameter Description
Status
Indicates validity of the job with
respect to connected tool.
ID
Indicates the Job ID.
NOTE:
A
Job
ID
can
be
used
for
Job
selection
by
DIO,
Fieldbus
or
MES
protocols.
Job
Indicates
the
name
given
to
identify
the
job.
To
edit
the
job,
select
the
job.
Interlocks
Information
related
to
interlocks
as
set
in
the
job.
Delete Select
to
delete
the
job.
Setup Job
Do the following to create a new job:
To
create
a
job,
select
Setup
Job.1.
The
Create
Job
screen
will
be
displayed.
To enable or disable the tool based on user defined criteria, from the Interlocks, select if
applicable:
2.
NOTE : Interlocks aid the user in enforcing line controls.
Valid
Job:
When
a
job
is
selected,
the
tool
is
enabled
if
there
are
no
other
interlocks
preventing
the
tool
from
getting
enabled.
When
the
job
is
complete,
the
tool
gets
disabled
and
the
job
selection
is
cleared.
The
user
must
select
a
job
in
order
to
run
the
tool
again.
The
user
can
select
the
same
job
or
a
different
job.
x
Barcode :
The
tool
is
disabled
until
a
valid
barcode
is
scanned.
Once
a
barcode
is
scanned,
the
tool
will
run
the
selected
job.
Once
the
job
completes
or
aborts,
the
tool
will
be
disabled
until
the
next
valid
barcode
is
scanned.
x
To Next Page
Loading...
