Ingersoll-Rand INSIGHTqc - Page 74

Tool Enable : The tool is disabled until an enable signal is received. The tool is
disabled when a disable signal is received. The enable or disable signals can come from
MES protocols, DIO, or Fieldbus. DIO and Fieldbus are governed by the setting for either 1
Line or 2 Line Enable or Disable in the spindle settings.
x
Smart Socket : The tool is disabled until the socket
assigned to the Pset is selected
from the socket tray. If wrong socket is selected, multiple sockets are selected or no socket
is selected, then the tool will be disabled. The check for valid socket selection is done at
the end of each tightening.
x
In the Name field, enter a name to identify the job.3.
In the ID field, the pre-populated number can be updated to any
other number between 1 to
255. If the number is already in use for any of the existing jobs, an error will be displayed.
4.
NOTE : A pre-populated number is displayed in the ID field based on the first available job
id. User has the option to retain the pre-populated number or choose any other number
between 1 to 255.
To select from the Existing Pset, select from the drop down list.5.
Else, continue to step 2 of Create Pset.
NOTE : A default Pset is generated when a job is created. This Pset can be modified or
deleted to meet the user requirement. If required, an existing Pset can be added to the job.
To create sequence and link Psets, select Rules .6.
NOTE : For each Pset, separate rule can be setup based on success
or failure result of the
Pset. If Pset has a batch count set to 5, completing that batch of 5 is a success result.
For success result, at Pass window, do the following:x
In the Action field, select a rule from the drop down list:x
None: No action.x
Jump to Pset: Jump to specific Pset.x
For failure result, at Fail window, do the following: x
In the Failure
Types field, select a rule from the drop down list:x
Hardware Faultx
High Torque.x
Low Torquex
High Anglex
Low Anglex
High Torque and Low Anglex
High Torque and High Anglex