Ingersoll-Rand INSIGHTqc - Page 85

Torque High Limit
Maximum acceptable torque value
during the fastening step.
Torque Low Limit
Minimum amount of torque that
must be reached during the
fastening step.
Angle High Limit (°)
Maximum angle of rotation
acceptable during the fastening
step.
Angle Low Limit (°)
Minimum angle of rotation
acceptable during the fastening
step.
Control Point
Set-Point/Target to achieve for
either torque or angle depending
on the step type.
Down Shift Speed
(RPM)
Displays the down shift speed in
RPM.
Dual Slope A High
Limit
High limit of slope in region 'A'.
Dual Slope A Low
Limit
Low limit of slope in region 'A'.
Dual Slope B High
Limit
High limit of slope in region 'B'.
Dual Slope B Low
Limit
Low limit of slope in region 'B'.
Gradient High Limit High limit of slope in region 'A'.
Gradient Low Limit Low limit of slope in region 'A'.
Tare Compensation
If enabled, the Average Prevailing
Torque is added to the Torque
Step's Target Torque, High Torque
Limit, and Low Torque Limit to
compensate for the Prevailing
torque. The modified Target is
checked against the modified
Torque Control's High/Low Torque
Limits for violation. If outside the
limits, the step declares an error.