Ingersoll-Rand INSIGHTqc - Page 86

NOTE : Tare Compensation is
only available if the Final
tightening step is Torque Control
and must follow a Prevailing-
Torque step.
Total Batch Count
Specifies the total number of
fasteners to be fastened in a
batch.
Current Batch Count
Present value of batch count to
indicate which fastener in the
batch was fastened to generate
the result.
Torque Display Units
Indicates the Torque unit. Nm is
the default unit.
Free Speed (RPM)
Speed at which tool will run before
reaching the Torque Shiftdown
Point.
Transducer Range
Field represents a calibrated
torque value that is used to scale
the internal torque measurements.
Max. Tool Speed
(RPM)
Displays maximum tool speed in
RPM.
Tool Serial Number
Indicates serial number of the tool
connected to the fastening
controller that generated the
fastening result.
Total Angle High
Pass
Indicates the total angle high
result.
Total Angle Low Pass Indicates the total angle low result.
Close
Go Back