basic configuration instead of advanced options.
Router will reboot if cannot dialup for a long
time and reach the max retry time
Enable—Local device connected to Router
can access to the Internet via Router.
Disable—Local device connected to Router
cannot access to the Internet via Router.
Select network provider for inserted SIM card
Select network type, router will try 4G, 3G,
2G in proper order if select in Auto
Optional Always Online, Connect On
Demand, Manual. It will support to configure
Triggered by SMS if select Connect On
Demand mode,
Set the redialing time when dial up fails.
Some of CR202 types support eSIM, enable
this option to enable eSIM dial up
Select network provider for eSIM card
For setting eSIM PIN code
Set the ISP that eSIM card connects to
Set the SIM card that uses to dialup at first
Set max number of dial, if cannot dial up
successfully after this number, router will
switch SIM card
Set threshold of signal, if current signal level
is lower than this, router will switch SIM card
Set the min connect time for each try of dial
up
Set customize initial AT commands which
will be operated at the beginning of dialing up
For setting PIN code of SIM
Set max transmission unit after enable
Click to receive peer DNS assigned by the
ISP
Set link detection interval
To Next Page
Loading...