InHand CR202 - III. Web Configuration; 3.4 Firewall; 3.4.8 MAC-IP Binding; 3.5 QoS

16
PPPoE is a point-to-point protocol over Ethernet. User has to install a PPPoE Client on the basis
of original connection way. Through PPPoE, remote access devices could achieve the control and
charging of each accessed user.
WAN/LAN1 is working as LAN by default.
Table 3-2-2-1 Static IP Parameters of WAN
WAN - Static IP
Function description: Access to Internet via wired lines with fixed IP.
Parameters
Description
Default
Shared connection (NAT)
Enable—Local device connected to
Router can access to the Internet via
Router.
Disable—Local device connected to
Router cannot access to the Internet via
Router.
Enable
Default route
Enable default route
Enable
MAC Address
MAC Address of the device
Device’s MAC
address
IP Address
Set IP address of WAN
192.168.1.29
Netmask
Set subnet mask of WAN
255. 255. 255. 0
Gateway
Set gateway of WAN
192. 168. 1. 1
MTU
Max. transmission unit, default/manual
settings
default (1500)
Multiple IP support (at most 8 additional IP addresses can be set)
IP Address
Set additional IP address of LAN
N/A
Subnet mask
Set subnet mask
N/A
Description
For recording significance of additional
IP address
N/A
Table 3-2-2-2 Dynamic Address (DHCP) Parameters of WAN
WAN - Dynamic Address (DHCP)
Function description: Set WAN in DHCP mode to get the address allocated by other routers
automatically.
Parameters
Description
Default
Shared connection (NAT)
Enable—Local device connected to
Router can access to the Internet via
Router.
Disable—Local device connected to
Router cannot access to the Internet via
Router.
Enable