InHand CR202 - Device Manager; Route Table; Device List; Log

37
WAN includes MAC address, connection type, IP address, netmask, gateway, DNS, MTU, Status
and etc.
Dialup includes connection type, IP address, netmask, gateway, DNS, MTU, status and connection
time.
LAN includes connection type, MAC address, IP address, netmask, gateway, MTU and DNS.
3.9.7 Device Manager
From navigation tree, select Status >> Device Manager, then enter “Device Manager” page to
check the connections status between router and Device Manager.
3.9.8 Route Table
From navigation tree, select Status >> Route Table, then enter “Route Table” page to see router
status.
This page displays the active route table, including destination, netmask, gateway, metric and
interface.
3.9.9 Device List
From navigation tree, select Status >> Device List, then enter “Device List” page to inquire the
device list.
This page displays the device list, including interface, MAC address, IP address, host and lease
(click MAC address to link to IEEE to inquire validity of the address).
3.9.10 Log
From navigation tree, select Status >> Log, then enter “Log” page.
This page displays the logs, including select to see the number of log lines (20/50/....../all), log
level (information, debug and warning), time, module and content. Clear log, download log file,
download system diagnosis record (refresh rate of this page is 5/10/…... 1min by default)