InHand IR611-S - System Log Configuration

11
admin functions (without influencing router
configuration)
Console Login User (Click <new> button after setting a group of username and password)
Username
Configure console login user, custom
N/A
Password
Configure the password, custom
N/A
Other Parameters
Log Timeout
Set login timeout (router will automatically disconnect
the configuration interface after login timeout)
500 seconds
 In “Username/Password” section, users can modify username and password rather than
create new username, i.e. only this username can be used in logins.
 In “Console Login User” section, we can create multiple usernames, i.e. multiple
usernames can be used by serial port or TELNET console logins.
3.1.5 System Log
A remote log server can be set through “System Log Settings,” and all system logs will be
uploaded to the remote log server through the gateway. This makes remote log software, such as
Kiwi Syslog Daemon, a necessity on the host.
Kiwi Syslog Daemon is free log server software for Windows. It can receive, record and display
logs from host (such as gateway, exchange board and Unix host). After downloading and installing
Kiwi Syslog Daemon, it must be configured through the menus “File >> Setup >> Input >> UDP.
From the navigation tree, select System >> System Log, then enter “System Log” page.
Table 3-1-5 Parameters of System Log
System Log
Function description: Configure IP address and port number of remote log server which will
record router log.
Parameters
Description
Default
Log to Remote System
Enable log server
Disable
Log server address and
port (UDP)
Set address and port of remote log server
N/A:
514
Log to Console
Output device log by serial port
Disable