21
network devices so that they will have normal network communication.
Click the “Network>>WLAN” menu in the navigation tree to enter the “WLAN" interface.
Table 3-2-6 Parameters of WLAN Access Port
Function description: Support WiFi function and provide wireless LAN access on site and
identity authentication of wireless user.
After turning on, use can search the WLAN via SSID name
Six type for options: 802. 11g/n, 802. 11g, 802. 11n, 802.
11b, 802. 11b/g , 802. 11b/g/n
SSID name defined by user
Support open type, shared type, auto selection of WEP,
WPA-PSK, WPA, WPA2-PSK, WPA2, WPA/WPA2,
WPAPSK/WPA2PSK
Support NONE, WEP40 and WEP104 as per different
authentication methods
Both 20MHz and 40MHz for selection
3.2.7 WLAN Client (STA Mode)
When working in STA mode, the device WLAN will enable normal network communication by
connecting to the device at network access point.
Click the “Network>>WLAN Client” menu in the navigation tree to enter the “WLAN” interface.
Select “Client” for the interface type and configure relevant parameters. (At this moment, the
dialing interface in the "Network>>Dialing Interface" should be closed.)
The scanning function of the SSID can be started only when selecting the Client at the WLAN
interface type. In the “SSID scanning” interface, all available SSID names as well as the connection
status of the device as Client will be displayed.
Table 3-2-7 Parameters of WLAN Client
Function description: Support WiFi function and access to wireless LAN access as client.
Support many modes including
802.11b/g/n
Name of the SSID to be connected
To Next Page
Loading...
