InHand IR720 series - Command Line Interface; Console and Telnet Login Procedures

101
15 Appendix - Setting of Command Line
You can locally log in to the router through the console port or Telnet in the LAN to set command
line.
 Local login through the Console port: If is required to first set up a configuration environment,
see "15.1 Set up Configuration Environment through the Console Port” for related operations.
 Local login through Telnet: Please first ensure the network connectivity between the
supervisory computer and the router and then click the button < Start > at the lower left corner
of the screen to enter the "Start" menu. Select [Run] and enter "telnet xxx.xxx.xxx.xxx"
(xxx.xxx.xxx.xxx is the IP address of the router’s LAN port) in the pop-up "Run" dialog box.
Press “Enter” and enter the user name and password (the user name is adm and password is
123456 by default) according to the interface prompt to log in the router for setting. For the
introduction of specific command line, please refer to "15.2 Online Help of Command Line”.
The router provides you with the following simple command-line maintenance:
Command Line
Please see
password (only limited to configuration
through the Console port)
15.3.1
ip address
15.3.2
erase
15.3.3
reboot
15.3.4
Show version
15.3.5
show running-config
15.3.6
show mac address-table
15.3.7
ping
15.3.8
In this manual, the command line management through logging in to the router via the
Console port is taken as an example.