InHand VG710 - Page 5

Connect the network cable between the device and terminal.
Currently, InHand Networks does not define the application scenarios of the USB interface.
Step 1: Connect to the device through the network cable or Wi-Fi (see the SSID and key on the nameplate).
If you use Wi-Fi, the Wi-Fi indicator is steady on in green or blinks.
Step 2: Enter the default device IP address 192.168.2.1 in the address bar of the web browser to open the
login page.
Step 3: Enter the default username adm and password 123456 to go to the web interface.
(2) Verifying the dial-up, GNSS, and OBD functions
1
2
3
Network
cable
Wi-Fi
5. Status Confirmation
(6) Connecting the network cable
(7) USB interface
(1) Logging into the device web interface
VG710 Onboard Gateway Quick Start Guide 5 / 6