5.6.2 Dynamic Routing
Scenario: Enable dynamic routing between two LANs for mutual communication between
them. The topology is shown below.
5.6.2.1 RIP
The Routing Information Protocol (RIP) is a simple internal dynamic routing
protocol mainly used on small-scale networks.
Method for enabling dynamic routing between VG814_A and VG814_B over RIP in the
scenario:
1. Configure VG814_A. Click "Routing >> Dynamic Routing >> RIP", check "Enable",
and configure VG814_A in the "Network" bar to announce the routing entry of
VG814_A.
To Next Page
Loading...