To Next PageTo Next Page
Need help?Do you have a question about the injen technology RD1482 and is the answer not in the manual?
Disconnect battery terminal and ensure engine is cool before starting installation procedures.
Unplug vacuum hose from intake duct and remove front bumper for filter placement.
Remove PCV hard pipe connecting breather hose and coolant lines once the engine has cooled.
Use 1/4" coupler to join bypass water coolant lines, securing with stock clamps.
Move ground wire to pre-tapped hole and screw in vibra-mount using nut and washer.
Press 2 3/4" end of step hose onto throttle body and secure with two clamps.
Insert intake top section into step hose, align bracket to vibra-mount, and secure with nut/washer.
Press 3 1/2" Injen filter onto intake's swaged end and tighten the clamp securely.
Connect 14"-10mm vacuum hose between valve cover port and intake's 1/2" nipple.
Align intake for best fit and tighten all nuts, bolts, and clamps for proper clearance.
Replace front bumper and reconnect the negative battery terminal.
Remove tools and rags from the engine compartment before starting the engine.
Congratulations on completing the Injen cold air intake installation.
General| Brand | injen technology |
|---|---|
| Model | RD1482 |
| Category | Automobile Accessories |
| Language | English |
