11-0142
PSN-1
User Manual
Warning!
The Oxygen Sensor used in this device gets very hot in operation.
Do not touch a hot sensor. Do not let a hot sensor touch a combustible surface. Do not use the
sensor with or near flammable liquids or gases. Failure to heed these warnings may result in
severe burns, explosions, fires, or other dangerous events.
1. PSN-1 ....................................................................................................... 2
1.1 Changing the PSN-1’s gauge face and/or bezel ............................. 3
Installation ................................................................................................ 4
2
2.1 Wiring ............................................................................................... 4
2.1.1 Single Innovate Device Relay Wiring Instructions ....................... 5
2.2 Gauge Mounting and Routing ......................................................... 5
2.3 PowerSafe Relay ............................................................................. 6
2.4 Nitrous Bottle Pressure Sensor ....................................................... 7
2.5 Wideband Oxygen Sensor Setup .................................................... 7
2.6.1 Sensor Calibration ....................................................................... 8
2.6.2 Calibration Schedule ................................................................... 9
PSN-1 Setup .......................................................................................... 10
3
3.1 Entering Setup Configuration ........................................................ 10
3.1.1 Configuration using PSN-1’s interface buttons ......................... 10
3.1.2 Configuration using the LM Programmer software .................... 10
3.2 Display Settings (Gauge Abbreviations) ........................................ 11
3.3 RPM Settings (Gauge Abbreviations) ........................................... 12
3.4 Nitrous Safety Settings (Gauge Abbreviations) ............................. 12
Logworks 3 & LM Programmer Software Package ................................ 13
4
4.1 Download and Install the Logworks 3 Software ............................ 13
4.2 LM Programmer ............................................................................. 13
4.2.1 Programming Analog Output ..................................................... 13
4.2.2 Advanced Analog Output Programming .................................... 14
4.2.3 Updating the Firmware .............................................................. 14
4.2.4 Changing Sensor Type .............................................................. 15
4.3 Logging data from your PSN-1 with LogWorks ............................. 16
Appendix A: Limited Warranty ....................................................................... 17
Appendix B: PSN-1 Error Codes and Troubleshooting Tips ......................... 18
To Next Page
Need help?
General
