Innovate DLG-1 User Manual

DLG-1
User Manual
Warning!
The Oxygen Sensor used in this device gets very hot in operation.
Do not touch a hot sensor. Do not let a hot sensor touch a combustible surface. Do not use the
sensor with or near flammable liquids or gases. Failure to heed these warnings may result in
severe burns, explosions, fires, or other dangerous events.

Innovate DLG-1 Specifications

General

Brand	Innovate
Model	DLG-1
Category	Monitor
Language	English

Summary

DLG-1 Overview

Installation

Wiring

Detailed wiring guide for connecting the DLG-1 and LC-2 to the vehicle's power and ground.

Interfacing DLG-1 with LC-2

Wideband Oxygen Sensor Setup

Oxygen Sensor Placement

Guidance on welding the exhaust bung for optimal oxygen sensor placement and accuracy.

Impact of Exhaust Leaks on Accuracy

Sensor Calibration

Initial Sensor Calibration Steps

Steps for applying power and ensuring sensors are disconnected for calibration.

Connecting Sensors for Calibration

Instructions on powering down, connecting sensors, and ensuring they are in free air.

Gauge Calibration Process

Describes the gauge display indicators during warming and calibration phases.

DLG-1 Configuration

Entering Setup Configuration

Gauge Button Configuration

LM Programmer Software Configuration

Instructions for connecting to a computer and using LM Programmer for configuration.

Logworks and LM Programmer Software

LM Programmer Functionality

Programming Analog Output Settings

Advanced Analog Output Options

Firmware Update Procedure

Changing Sensor Type

Logging Data with LogWorks

Adding MTS Channels for Logging