585
8
8 Electronic Cam 8.9 Application Examples (Application of H3U-PM to Strapping Band Winding Machines)
The cam moves from the middle of the spool to B and then to A, and returns to the middle of the spool. This
completes a cam cycle.
4) Cam Programming
Set X axis as an input channel of master axis
Set the cam table number
Set A/B phase counting for the X axis
Start Source of X axis inputs
X axis cyclic enabling
Selecting the X
axis stop mode
Setting the X axis
cam input axis number
Setting the X axis
cam table
Setting X axis pulse
input and counting
Set externally input master axis
Set cyclic execution of X axis cam
Set an immediate stop of X axis cam
To Next Page
Loading...
