Inovance H3U Series - Page 678

677
10
10 Extension Modules 10.2.5 Analog Output Module (AM600-4DA)
On the
General Conguration
interface of the AM600-4DA module, enable Channel-0, and congure
Conversion Mode
as
-10V~10V
voltage output.
State Output After Stop
can also be congured.
On the conguration interface, enable the corresponding channel. Disable unused channels to reduce the
scan duration.
Select voltage or current of different modes from the
Translate Mode
drop-down list. In this example,
Translate Mode
is congured as
-10V~10V
voltage output.
Output state after Stopping
sets the module output condition when the PLC is in the stopped state. The
options include
Output zero
,
Output hold
, and
Output preset
.