5 Parameter Table
- 34 -
Para� No� Para� Name Setting Range Unit Default Property
F9-18 The third last fault 0: no fault
1: reserved
2: overcurrent (E02)
3: overcurrent (E03)
4: overcurrent (E04)
5: overvoltage (E05)
6: overvoltage (E06)
7: overvoltage (E07)
8: reserved
9: undervoltage (E09)
10: drive overload (E10)
12: input phase loss (E12)
13: output phase loss (E13)
14: heatsink overheat (E14)
15: external fault (E15)
16: modbus fault (E16)
17: contactor fault (E17)
18: current sensing fault (E18)
19: motor tuning fault (E19)
20: reserved (E20)
21: EEPROM fault (E21)
22: reserved (E22)
23: ground fault (E23)
24 to 25: reserved
26: time is out (E26)
27: bussiness time is out (E27)
28 to 39: reserved 40: multi
times overcurrent (E40)
41: reserved
42: can communication fault (E42)
43: resolver tuning fault (E43)
44: speed error protection fault (E44)
45: motor overheat (E45)
46: pump sensor fault (E46)
47: slave fault warning (E47)
48: can address concting (E48)
49: resolver loose wiring (E49)
52: multi masters fault (E52) 58: user
parameter restore fault (E58)
59: back EMF error (E59)
61: braking overtime (E61)
62: braking IGBT fault (E62)
63: reverse running time out (E63) 66: braking
resistor fault (E66) 67: function code
initialization fault (E67)
1 - ●
F9-19 The second last fault 1 - ●
F9-20 The last fault 1 - ●
F9-21 Frequency upon the last fault - - - ●
F9-22 Current upon the last fault - - - ●
F9-23 Bus voltage upon the last fault - - - ●
F9-24 DI status upon the last fault - - - ●
F9-25 DO status upon the last fault - - - ●
F9-26 The subtype of the last fault - - - ●
F9-30 Frequency upon the second last fault - - - ●
F9-31 Current upon the second last fault - - - ●
F9-32 Bus voltage upon the second last
fault
- - - ●
F9-33 DI status upon the second last fault - - - ●
F9-34 DO status upon the second last fault - - - ●
To Next Page
Loading...
