Inovance MD200 - Page 51

5 Parameter Table
- 50 -
Para. No. Para. Name Setting Range Default Comms. Address
A1-21 VDO active mode selection
00000 to 11111
VDO2:
0: Positive logic active
1: Negative logic active
VDO1:
0: Positive logic active
1: Negative logic active
VDO3:
0: Positive logic active
1: Negative logic active
VDO5:
0: Positive logic active
1: Negative logic active
VDO4:
0: Positive logic active
1: Negative logic active
00000 0xA115/0x4115
Group A5: Control Optimization
A5-00
DPWM switchover frequency
upper limit
0.00 Hz to max. frequency 12.00 Hz 0xA500/0x4500
A5-02
Dead zone compensation mode
selection
0: No compensation
1: Compensation mode 1
1 0xA502/0x4502
A5-03 Random PWM depth
0: Random PWM invalid
1 to 10: PWM carrier frequency random depth
3 0xA503/0x4503
A5-04 Overcurrent fast prevention
0: Disabled
1: Enabled
1 0xA504/0x4504
A5-05 Max. output voltage coefcient 100% to 110% 103% 0xA505/0x4505
A5-06 Undervoltage threshold 140.0 to 420.0 V
Single phase:
200.0 V
Three phase:
350.0 V
0xA600/0x4600
A5-08
Low speed carrier frequency
upper limit
0.0 to 6.0 kHz 0.0 0xA508/0x4508
A5-09 Overvoltage threshold 200.0 to 820.0 V
Single phase:
410.0 V
Three phase:
820.0 V
0xA509/0x4509
Group A6: AI Curve Setting
A6-24
Jump point of AI1 input
corresponding setting
-100.0% to 100.0% 0.0% 0xA618/0x4618
A6-25
Jump amplitude of AI1 input
corresponding setting
0.0% to 100.0% 0.5% 0xA619/0x4619
A6-26
Jump point of AI2 input
corresponding setting
-100.0% to 100.0% 0.0% 0xA61A/0x461A
A6-27
Jump amplitude of AI2 input
corresponding setting
0.0% to 100.0% 0.5% 0xA61B/0x461B
Group AA: FVC/SVC Extension Parameters
AA-05 SVC speed lter 5 to 32 ms 15 ms 0xAA05/0x4A05
AA-06 SVC speed feedback method 0 to 3 0 0xAA06/0x4A06
AA-07
SVC magnetic eld adjustment
bandwidth
0.5 to 8.0 Hz 4.0 Hz 0xAA07/0x4A07