Inovance MD280 Series - Page 128

Parameter Description MD280/MD280N User Manual
- 128 -
Setup
value
Function Description
19
Speed-up/speed-
down disabled
When this terminal command is valid, it
can maintain the current frequency output
while stopping.
20 PID pause
When this terminal command is valid, the
PID stops adjustment, and the inverter
maintains the current frequency output.
21 PLC status reset
When this terminal command is valid, it
clears the memorized PLC running phase
and running time, and restores to the
initial status of PLC running.
22
Swing frequency
pause
When this terminal command is valid, the
inverter maintains the frequency output of
the swing frequency center, and the swing
frequency pauses.
23
Counter input
(DI5)
It is used as input terminal of the counting
pulse.
24 Counter reset
When this terminal command is valid, it
clears the counting value of the counter to
zero.Refer to the description of F7-08 and
F7-09 function codes for the counting
function.
25
Length counting
input (DI5)
It is used as pulse input terminal of the
length counting.
26
Length counting
reset
When this terminal is valid, it clears the
length counting to zero. Refer to the
description of F7-05, F7-06 and F7-07
function codes for the length counting
function.
27
Interchange of AI1
and AI2 settings
When this terminal command is valid,
interchange AI1 and AI2 setting value. But
it does not affect the maximum input
corresponding setting mode of
AI1 and AI2.
28
Frequency source
switching
switches to
AI1
When the terminal command is valid, the
current frequency switches to AI1
reference.It is valid only for setting F0-18
˄ frequency source overlapping
selection˅to 0.
efesotomasyon.com