Inovance MD280NT2.2GB - Page 105

Description of Function Codes MD280 User Manual
- 104 -
Note
7KHPDLQIUHTXHQF\VRXUFH;DQGDX[LOLDU\IUHTXHQF\VRXUFH<PXVWQRWXVHWKHVDPHFKDQQHO
That is, F0-01 and F0-15 cannot be set to the same value.
Function Code Parameter Name Setting Range Default
F0-16 %DVHRIDX[LOLDU\IUHTXHQF\<
5HODWLYHWRPD[LPXP
frequency
1: Relative to main frequency
X
0
F0-17
5DQJHRIDX[LOLDU\IUHTXHQF\
Y
0%–150% 100%
,I;DQG<VXSHUSRVLWLRQ) RULVXVHGWKHVHWZRSDUDPHWHUVDUHXVHGWRVHWWKH
PRGL¿FDWLRQUDQJHRIWKHDX[LOLDU\IUHTXHQF\VRXUFH
<RXFDQVHWWKHDX[LOLDU\IUHTXHQF\ WREHUHODWLYHWRHLWKHUPD[LPXPIUHTXHQF\RUPDLQ
IUHTXHQF\;,IUHODWLYHWRPDLQIUHTXHQF\;WKHVHWWLQJUDQJHRIWKHDX[LOLDU\IUHTXHQF\<
varies according to the main frequency X.
Function Code Parameter Name Setting Range Default
F0-18
Frequency source
superposition
0: Main frequency source X
1: X and Y superposition
2: Switchover between X and Y
3: Switchover between X and "X and Y
superposition"
4: Switchover between Y and "X and Y
superposition"
0
It is used to select the frequency setting channel.
When this parameter is set to the value other than 2, 3, or 4, the switchover can be
implemented by the DI with the frequency source switchover function.
Function Code Parameter Name Setting Range Default
F0-20
)UHTXHQF\RIIVHWRIDX[LOLDU\IUHTXHQF\
source for X and Y superposition
0.00 Hz to
PD[LPXP
IUHTXHQF\)
0.00 Hz
This parameter is valid only when the frequency source is set to "X and Y superposition".
7KH¿QDOIUHTXHQF\LVREWDLQHGE\DGGLQJWKHIUHTXHQF\RIIVHWVHWLQWKLVSDUDPHWHUWRWKH;
and Y superposition result.
Function Code Parameter Name Setting Range Default
F0-21 Carrier frequency adjustment with temperature
0: No
1: Yes
1
It is used to set whether the carrier frequency is adjusted based on the temperature. The
AC drive automatically reduces the carrier frequency when detecting that the heatsink
efesotomasyon.com