Inovance MD280NT2.2GB - Page 122

MD280 User Manual Description of Function Codes
- 121 -
WKHRXWSXWLV9 ZKHQWKH IUHTXHQF\LVDQG9 P$DWWKHPD[LPXPIUHTXHQF\WKH
gain shall be set to -0.50, and the zero offset shall be set to 80%.
Function Code Parameter Name Setting Range Default
F3-08 0D[LPXP)03RXWSXWIUHTXHQF\ 0.1–50.00 kHz 50.00 kHz
,IWKH)0WHUPLQDO) LVXVHGIRUSXOVHRXWSXWWKLVSDUDPHWHU LVXVHGWRVHWWKH
PD[LPXPIUHTXHQF\RISXOVHRXWSXW
Function Code Parameter Name Setting Range Default
F3-09 Relay output delay time
0.0–3600.0s 0.0s
F3-10 DO1 output delay time
0.0–3600.0s 0.0s
F3-11 DO2 output delay time
0.0–3600.0s 0.0s
F3-12 DO3 output delay time
0.0–3600.0s 0.0s
7KHVHSDUDPHWHUVDUHXVHGWR VHWWKHGHOD\WLPHRIRXWSXWWHUPLQDOV '2[IURPVWDWXV
FKDQJHWRDFWXDORXWSXW7KH'2[VLJQDOFDQ EHUHFRJQL]HGRQO\ZKHQWKHZLGWKRIWKH
signal is larger than the value of the corresponding parameter.
)LJXUH'2[RXWSXWGHOD\
Signal width
1w
t
2w
t
'2[RXWSXWGHOD\WLPH
Signal
before delay
Signal
after delay
Signal width
Function Code Parameter Name Setting Range Default
F3-13 DO valid state selection
0–15 0
7KLVSDUDPHWHUGH¿QHVWKHYDOLGVWDWHRI'2WHUPLQDOVE\ELW
 0: Positive logic
The terminal is valid when being connected with COM, and invalid when being
disconnected from COM.
 1: Negative logic
The terminal is invalid when being connected with COM, and valid when being
disconnected from COM.
Bit BIT2 BIT2 BIT1 BIT0
Terminal DO3 DO2 DO1 Relay
To set a DI as the negative logic, set the corresponding bit to 1, convert the binary value to a
decimal value, and then set the decimal value in this function code.
efesotomasyon.com