Inovance MD380-5T5.5GB - Page 142

MD380 User Manual Desc
ription of Function Codes
- 141 -
)unction Code Parameter Name Setting Range Default
)0-07
)requency source
selection
Unit's digit ()requency source selection)
0
0: Main frequency source X
1: X and Y
operation
(operation relationship determined by ten's
digit)
2: Switchover between X and Y
3: Switchover between X and "X and Y
operation"
4: Switchover between Y
and "X and Y
operation"
Ten's digit (X and Y operation relationship)
0: X+Y
1: X-Y
2: Maximum
3: Minimum
It is used to select the frequency setting channel. If the frequency source involves X and
<RSHUDWLRQ\RXFDQVHWWKHIUHTXHQF\RIIVHWLQ)IRUVXSHUSRVLWLRQWRWKH;DQG<
RSHUDWLRQUHVXOWÀH[LEO\VDWLVI\LQJYDULRXVUHTXLUHPHQWV
)LJXUH)UHTXHQF\VHWWLQJEDVHGRQPDLQIUHTXHQF\VRXUFH;DQGDX[LOLDU\IUHTXHQF\
source Y
)UHTXHQF\
source selection
)UHTXHQF\VRXUFH;DQG
Y operation selection
Setting of operation
conditions
Target running
frequency
)0-07 unit's
digit
Set frequency
)UHTXHQF\
switchover
)4-00 WR)4-09
= 18
DI1 to DI10
)0-07 ten's
digit
Amplitude
limit
Auxiliary
frequency
source Y
Main
frequency
source X
efesotomasyon.com