Inovance MD380-5T5.5GB - Page 207

Description of Function Codes
MD380 User Manual
- 206 -
)LJXUH$&GULYHDFWLRQGLDJUDPXSRQLQVWDQWDQHRXVSRZHUIDLOXUH
%XVYROWDJH
Action judging voltage at
instantaneous power failure
)9-62
Voltage rally judging time at
instantaneous power failure
)9-61
Running
frequency
Action pause judging
voltage at instantaneous
power failure)9-60
Action pause judging
voltage at instantaneous
power failure)9-60
Running
frequency
)9-59 = 1: Decelerate
Deceler
-ation
time 3
Deceler
-ation
time 4
Acceler
ation
time
Deceler-
ation time
3
Deceler-
ation time
4
)unction Code Parameter Name Setting Range Default
)9-63 Protection upon load becoming 0
0: Disabled
1: Enabled
0
)9-64 Detection level of load becoming 0
0.0%–100.0% (rated
motor current)
10.0%
)9-65 Detection time of load becoming 0 0.0–60.0s 1.0s
If protection upon load becoming 0 is enabled, when the output current of the AC drive
LVORZHUWKDQWKHGHWHFWLRQOHYHO)DQGWKHODVWLQJWLPHH[FHHGVWKHGHWHFWLRQWLPH
)WKHRXWSXWIUHTXHQF\RIWKH$&GULYHDXWRPDWLFDOO\GHFOLQHVWRRIWKHUDWHG
frequency. During the protection, the AC drive automatically accelerates to the set frequency
if the load resumes to normal.
)unction Code Parameter Name Setting Range Default
)9-67 Over-speed detection value 0.0%–50.0% (maximum frequency) 20.0%
)9-68 Over-speed detection time 0.0–60.0s 1.0s
This function is valid only when the AC drive runs in the CLVC mode.
If the actual motor rotational speed detected by the AC drive exceeds the maximum
IUHTXHQF\DQGWKHH[FHVVLYHYDOXHLVJUHDWHUWKDQWKHYDOXHRI)DQGWKHODVWLQJWLPH
H[FHHGVWKHYDOXHRI)WKH$&GULYHUHSRUWV(UUDQGDFWVDFFRUGLQJWRWKHVHOHFWHG
fault protection action.
If the over-speed detection time is 0.0s, the over-speed detection function is disabled.
efesotomasyon.com