Inovance MD380-5T5.5GB - Page 219

Description of Function Codes
MD380 User Manual
- 218 -
)unction Code Parameter Name Setting Range Default
)C-34 Running time of simple PLC reference 8 0.0–6553.5s (h) 0.0s (h)
)C-35
Acceleration/deceleration time of simple
PLC reference 8
0–3 0
)C-36 Running time of simple PLC reference 9 0.0–6553.5s (h) 0.0s (h)
)C-37
Acceleration/deceleration time of simple
PLC reference 9
0–3 0
)C-38 Running time of simple PLC reference 10 0.0–6553.5s (h) 0.0s (h)
)C-39
Acceleration/deceleration time of simple
PLC reference 10
0–3 0
)C-40 Running time of simple PLC reference 11 0.0–6553.5s (h) 0.0s (h)
)C-41
Acceleration/deceleration time of simple
PLC reference 11
0–3 0
)C-42 Running time of simple PLC reference 12 0.0–6553.5s (h) 0.0s (h)
)C-43
Acceleration/deceleration time of simple
PLC reference 12
0–3 0
)C-44 Running time of simple PLC reference 13 0.0–6553.5s (h) 0.0s (h)
)C-45
Acceleration/deceleration time of simple
PLC reference 13
0–3 0
)C-46 Running time of simple PLC reference 14 0.0–6553.5s (h) 0.0s (h)
)C-47
Acceleration/deceleration time of simple
PLC reference 14
0–3 0
)C-48 Running time of simple PLC reference 15 0.0–6553.5s (h) 0.0s (h)
)C-49
Acceleration/deceleration time of simple
PLC reference 15
0–3 0
)C-50 Ti
me unit of simple PLC running
0: s (second)
1: h (hour)
0
)unction Code Parameter Name Setting Range Default
)C-51 Reference 0 source
0: Set by )C-00
1: A
I1
2: A
I2
3: AI3
4: Pulse setting
5: PID
6: Set by preset frequency ()0-08),
modi¿ed via terminal UP/DOWN
0
It determines the setting channel of reference 0. You can perform convenient switchover
between the setting channels. When multi-reference or simple PLC is used as frequency
source, the switchover between two frequency sources can be realized easily.
efesotomasyon.com