Inovance MD380-5T5.5GB - Page 245

Description of Function Codes
MD380 User Manual
- 244 -
 ,I)IUHTXHQF\UHIHUHQFHUHVROXWLRQLVWKHGLVSOD\UDQJHLV±+]
 ,I)IUHTXHQF\UHIHUHQFHUHVROXWLRQLVWKHGLVSOD\UDQJHLV±+]
)unction Code Parameter Name Display Range
U0-33 Synchronous motor rotor position
0.0°–359.9°
It displays the rotor position of the synchronous motor.
)unction Code Parameter Name Display Range
U0-34 Motor temperature 0–20
0 °C
,WGLVSOD\VWKHPRWRUWHPSHUDWXUHREWDLQHGE\PHDQVRI$,VDPSOLQJ)RUWKH PRWRU
WHPSHUDWXUHGHWHFWLRQVHH)
)unction Code Parameter Name Display Range
U0-35 Target torque -200.0%–200.0%
It displays the current torque upper limit.
)unction Code Parameter Name Display Range
U0-36 Resolver position 0–4095
It displays the current resolver position.
)unction Code Parameter Name Display Range
U0-37 Power factor angle -
It displays the current power factor angle.
)unction Code Parameter Name Display Range
U0-38 A%= position 0–65535
,WGLVSOD\VWKHSKDVH$DQG%SXOVHFRXQWLQJRIWKHFXUUHQW$%=RU89:HQFRGHU7KLVYDOXH
LVIRXUWLPHVWKHQXPEHURISXOVHVWKDWWKHHQFRGHUUXQV)RUH[DPSOHLIWKHGLVSOD\LV
the actual number of pulses that the encoder runs is 4000/4 = 1000.
The value increase when the encoder rotates in forward direction and decreases when the
encoder rotates in reverse direction. After increasing to 65535, the value starts to increase
from 0 again. After decreasing to 0, the value starts to decrease from 65535 again.
You can check whether the installation of the encoder is normal by viewing U0-38.
)unction Code Parameter Name Display Range
U0-39 Ta
rget voltage upon V/) separation 0 V to rated motor voltage
U0-40 Output voltage upon V/) separation 0 V to rated motor voltage
7KH\GLVSOD\WKHWDUJHWRXWSXWYROWDJHDQGFXUUHQWDFWXDORXWSXWYROWDJHLQWKH9)
VHSDUDWLRQVWDWH)RU9)VHSDUDWLRQVHHWKHGHVFULSWLRQVRIJURXS)
efesotomasyon.com