EasyManua.ls Logo

Inovance MD380-5T5.5GB - Page 294

Inovance MD380-5T5.5GB
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MD380 User Manual Maintenance and Troubleshooting
- 293 -
Table 9-2 Troubleshooting to common faults of the AC drive
SN )ault Possible Causes Solutions
1
There is no display
at power-on.
1: T
here is no power supply to the
AC drive or the power input to the
AC drive is too low.
2: T
he power supply of the switch
on the drive board of the AC drive is
faulty.
3: The recti¿er bridge is damaged.
4: The control board or the
operation panel is faulty.
5: T
he cable connecting the control
board and the drive board and the
operation panel breaks.
1: Check the power supply.
2: Check the bus voltage.
3: Re-connect the 8-core and
28-core cables.
4: Contact the agent or Inovance
for technical support.
2
³
H
C
is displayed
at power-on.
1: T
he cable between the drive
board and the control board is in
poor contact.
2: Related components on the
control board are damaged.
3: T
he motor or the motor cable is
short circuited to the ground.
4: The HALL device is faulty.
5: T
he power input to the AC drive
is too low.
1: Re-connect the 8-core and
28-core cables.
2: Contact the agent or Inovance
for technical support.
3
³
Err23
is displayed
at power-on.
1: T
he motor or the motor output
cable is short-circuited to the
ground.
2: T
he AC drive is damaged.
1: Measure the insulation of the
motor and the output cable with
a megger.
2: Contact the agent or
Inovance for technical support.
4
The A
C drive
display is normal
upon power-
on. %ut
³
HC
is
displayed after
running and stops
immediately.
1:The cooling fan is damaged or
locked-rotor occurs.
2: The external control terminal
cable is short circuited.
1: Replace the damaged fan.
2: Eliminate external fault.
5
Err14 (module
overheat) fault
is reported
frequently.
1: The setting of carrier frequency is
too high.
2: T
he cooling fan is damaged, or
the air ¿lter is blocked.
3: Components inside the AC drive
are damaged (thermal coupler or
others).
1: Reduce the carrier frequency
()0-15).
2: Replace the fan and clean the
air ¿
lter.
3: Contact the agent or Inovance
for technical support.
efesotomasyon.com

Table of Contents

Related product manuals