Inovance MD380-5T5.5GB - Page 52

MD380 User Manual Operation, Display and Application Example
- 51 -
)3LVXVHGWRGHWHUPLQHZKHWKHUWKHXVHUGH¿QHGJURXSDQGXVHUPRGL¿HGJURXSDUH
displayed.
)unction Code Parameter Name Setting Range Default
)P-03
Individualized
parameter display
property
Unit's digit:
-USEr
group display selection
11
0: Not display
1: Display
Te
n's digit:
--C--
group display selection
0: Not display
1: Display
-bASE
It indicates all function codes of the MD380. After the mode is switched over to
-bASE
,
level I menu is displayed.
-USEr
7KHXVHUGH¿QHGPHQXLVVHWWRIDFLOLWDWHYLHZLQJDQGPRGLI\LQJRIFRPPRQO\XVHGIXQFWLRQ
FRGHV,QWKLVPRGHWKHGLVSOD\SDUDPHWHUX)LQGLFDWHVIXQFWLRQFRGH)<RXFDQ
also modify parameters in this mode as in common editing state. After the mode is switched
over to
-USEr
, level II menu is displayed.
7KHXVHUGH¿QHGSDUDPHWHUVDUHLQFOXGHGLQJURXS)(,I)(LVVHWWR)LWLQGLFDWHVWKDW
QRIXQFWLRQFRGHVDUHDYDLODEOH$PD[LPXPRISDUDPHWHUVFDQEHLQFOXGHGLQJURXS)(
,I18//LVGLVSOD\HGLWLQGLFDWHVWKDWWKHXVHUGH¿QHGPHQXLVQXOO
$WRWDORISDUDPHWHUVDUHSUHVWRUHGLQWKHXVHUGH¿QHGPHQXDVOLVWHGLQWKHIROORZLQJ
table.
)0-01 Motor 1 control mode )3-01 Torque boost
)0-02 Command source selection )4-00 DI1 function selection
)0-03 Main frequency source X selection )4-01 DI2 function selection
)0-07 )requency source selection )4-02 DI3 function selection
)0-08 Preset frequency )5-04 DO1 function
)0-17 Acceleration time 1 )5-07 AO1 function selection
)0-18 Deceleration time 1 )6-00 Start mode
)3-00 V/) curve setting )6-10 Stop mode
<RXFDQHGLWWKHXVHUGH¿QHGPHQXEDVHGRQDFWXDOUHTXLUHPHQWV
--C--
In you modified menu, only the parameters that are modified to a non-default value are
displayed. The menu is generated by the AC drive automatically. After the mode is switched
over to
--C--
, level II menu is displayed.
efesotomasyon.com