Inovance MD380-5T5.5GB - Starting or Stopping the AC Drive

Operation, Display and Application Examples MD380 User Manual
- 54 -
When the AC drive is powered on again after power failure, the parameters that are selected
before power failure are displayed.
Select the required parameters by pressing . Set the values of the parameters by
referring to the following example.
1. Determine the parameters to be displayed.
5XQQLQJIUHTXHQF\%XVYROWDJH2XWSXWYROWDJH2XWSXWFXUUHQW2XWSXWIUHTXHQF\2XWSXW
torque, PID feedback, Encoder feedback speed
2. Set the binary data.
)%)%
3. Convert the binary data to hexadecimal data:
)'+)+
The values displayed on the operation panel are respectively H.1043 and H.2001
UHVSHFWLYHO\IRU)DQG)
4.7 Starting or Stopping the AC Drive
4.7.1 Selecting the Start/Stop Command Source
There are three start/stop command sources, namely, operation panel control, terminal
FRQWURODQGFRPPXQLFDWLRQFRQWURO<RXFDQVHOHFWWKHFRPPDQGVRXUFHLQ)
)unction
Code
Parameter
Name
Setting Range Description Default
)0-02
Command
source
selection
0: Operation panel control
(indicator O)))
1: Te
rminal control
(indicator ON)
2: Communication control
(indicator blinking)
Press
RUN
or
STOP
RES
to start
or stop the AC drive.
A
DI terminal needs to be de¿ned
as the run/stop terminal.
The Modbus-RT
U communication
protocol is used.
0
 0: Operation panel control
After you press
RUN
, the AC drive starts running (the RUN indicator is ON). After you
press
STOP
RES
when the AC drive is in running state, the AC drive stops running (the
581LQGLFDWRULV2))
 1: Terminal control
This control mode is applicable to scenarios where the DIP switch or electromagnetic
button is used to start or stop the application system or scenarios where the dry contact
signal is used to start or stop the AC drive.
efesotomasyon.com