Inovance MD380-5T5.5GB - Chapter 5 Unction Code Table; Standard Unction Parameters

Function Code Table
MD380 User Manual
- 80 -
Chapter 5 )unction Code Table
,I)3LVVHWWRDQRQ]HURQXPEHUSDUDPHWHUSURWHFWLRQLVHQDEOHG<RXPXVWHQWHUWKH
correct user password to enter the menu.
7RFDQFHOWKHSDVVZRUGSURWHFWLRQIXQFWLRQHQWHUZLWKSDVVZRUGDQGVHW)3WR
*URXS)DQG*URXS$DUHVWDQGDUGIXQFWLRQSDUDPHWHUV*URXS8LQFOXGHVWKHPRQLWRULQJ
function parameters.
The symbols in the function code table are described as follows:
"
ƿ": T
he parameter can be modi¿ed when the AC drive is in either stop or running state.
"ƾ
7KHSDUDPHWHUFDQQRWEHPRGL¿HGZKHQWKH$&GULYHLVLQWKHUXQQLQJVWDWH
Ɣ7KHSDUDPHWHULVWKHDFWXDOO\PHDVXUHGYDOXHDQGFDQQRWEHPRGL¿HG
"*": The parameter is factory parameter and can be set only by the manufacturer.
5.1 Standard )unction Parameters
)unction
Code
Parameter Name
Setting Range
Default Property
Group )0: Standard )unction Parameters
)0-00 G/P
type display
1: G type (constant torque load)
2: P type (variable torque load
e.g. fan and pump)
Model
dependent
ƽ
)0-01 Motor 1 control mode
0: Sensorless Àux vector control
(S)VC)
1: Closed-loop vector control
(CLV
C)
2: Vo
ltage/)requency (V/))
control
0 ƾ
)0-02 Command source selection
0: Operation panel control (LED off)
1: Terminal control (LED on)
2: Communication control (LED
blinking)
0 ƿ
)0-03
Main frequency source X
selection
0: Digital setting (non-retentive at
power failure)
1: Digital setting (retentive at
power failure)
2: AI1
3: AI2
4: AI3
0 ƾ
efesotomasyon.com