Inovance MD500-PLUS Series - Page 28

Parameter List
‑27‑
Parame
ter
Address Name Value Range Default Unit Change
Method
Page
Contin
ued
Contin
ued
Continued 15: Ready for RUN
16: AI1 > AI2
17: Frequency upper limit
reached
18: Frequency lower limit
reached (operation related)
19: Undervoltage status
output
20: Communication setting
21: Reserved
22: Reserved
23: Zero‑speed running 2 (at
stop)
24: Accumulative power‑on
time reached
Contin
ued
Contin
ued
Continued Continued
Contin
ued
Contin
ued
Continued 25: Frequency‑level detection
FDT2 output
26: Frequency 1 reach output
27: Frequency 2 reach output
28: Current 1 reach output
29: Current 2 reach output
30: Timing reach output
31: AI1 input limit exceeded
32: AC drive output load loss
33: Reverse running
34: Zero current status
35: Module temperature
reached
Contin
ued
Contin
ued
Continued Continued
Contin
ued
Contin
ued
Continued 36: Output current limit
exceeded
37: Frequency lower limit
reached (having output at
stop)
38: Alarm output (direct
output at fault or alarm)
39: Current over‑temperature
pre‑warning
40: Current running time
reached
41: Fault output 2
42: Fault output 3
Contin
ued
Contin
ued
Continued Continued
F5‑02 0xF502 Control board
relay 1 function
selection (T/A1‑T/
B1‑TC1)
0–42 2 ‑ In real time "
F5‑02 " on
page 190