Appendix. Parameter Table
- 332 -
Parameter No. Parameter Name Display Range Page
U0-37 Power factor angle -180° to 180°
1
5
1
U0-38 ABZ position 0 to 65535
1
5
2
U0-39 Target voltage upon V/F separation 0 V to rated motor voltage
1
5
2
U0-40 Output voltage upon V/F separation 0 V to rated motor voltage
1
5
2
U0-41 DI state display -
1
5
2
U0-42 DO state display -
1
5
2
U0-43 DI set for function state display 1 -
1
5
2
U0-44 DI set for function state display 2 -
1
5
3
U0-45 Fault information 0 to 51 -
U0-58 Phase Z counting 0 to 65535
1
5
3
U0-59 Frequency Reference -100.00% to 100.00%
1
5
3
U0-60 Running frequency -100.00% to 100.00%
1
5
3
U0-61 AC drive state 0 to 65535
1
5
3
U0-62 Current fault code 0 to 99
1
5
3
U0-63 Sending value of point-point
communication
-100.00% to 100.00%
1
5
3
U0-64 Number of slaves 0 to 63
1
5
3
U0-65 Torque upper limit -200.00% to 200.00%
1
5
3
U0-66 Communication extension card type 100: CANopen
200: PROFIBUS-DP
300: CANlink
-
U0-67 Communication extension card version - -
U0-69 Speed of transmitting DP 0.00 Hz to max. frequency -
U0-70 Motor speed of transmitting DP 0 to rated motor -
U0-71 Communication card current display - -
U0-72 Communication card faulty state - -
U0-73 Motor SN 0: Motor 1
1: Motor 2
-
U0-74 AC drive output torque -200.0% to 200.00%
1
5
3
U0-76 Low bits of accumulative power
consumption
0.0 to 999.0 (min. unit: 0.1°)
1
5
3
U0-77 High bits of accumulative power
consumption
0 to 65535 (min. unit: 1°)
1
5
3
U0-78 Linear speed 0 to 65535
1
5
3
To Next Page
Loading...
