7. Description of Parameters MD500 User Manual
- 170 -
Function Code Parameter Name Setting Range Default
F7-05 LED display stop parameters 0000 to FFFF
7 6 5 4 3 2 1 0
Bus voltage (V)
DO state
AI1 voltage (V)
Count value
Frequency reference (Hz)
DI state
AI2 voltage (V)
AI3 voltage (V)
15 14 12 11 10 8
PLC stage
Pulse reference (kHz)
Length value
Reserved
13
Load speed
PID reference
Reserved
Reserved
If a parameter needs to be displayed during the
running, set the corresponding bit to 1, and set
F7-05 to the hexadecimal equivalent.
1F
Note
ƕ Once the AC drive is re-powered on after power down, the displays are
the selected parameters before power down by default.
ƕ If the parameter to be monitored cannot be found in F7-03, F7-04 and F7-05, view it in group U0.
efesotomasyon.com
To Next Page
Loading...