Inovance MD500T75G - Page 34

2. Mechanical Installation MD500 User Manual
- 34 -
6HH)LJXUHDQG)LJXUHIRUH[DPSOHVWKDWVKRZKRZWRÀWWKHKDQJLQJEUDFNHWVWRWKHKRXVLQJ
Figure 2-6 Hanging bracket installation for a plastic housing
Fit the hanging bracket to the housing and secure
it to the housing by tightening the supplied screws.
Hanging
bracket
1 2
Installation of the hanging
bracket is completed.
Continue to
see Figure 2-8
Figure 2-7 Hanging bracket installation for a sheet metal housing
Hanging
bracket
Installation of the hanging
bracket is completed.
Fit the hanging brackets to the housing and secure it to
the housing by tightening the supplied screws and bolts.
1 2
Hanging
bracket
Continue to
see Figure 2-
3. Make sure all the screws and bolts that secure the hanging brackets to the housing are tight.
Ƶ
Stage 2: Preparing the Mounting Surface
4. Refer to Table 2-1 to identify your model of MD500 housing, and make a careful note of the following dimensions:
ƕ The mounting hole distances A and B
ƕ The mounting hole diameter d
ƕ The overall dimensions of the housing H and W
5. Mark the mounting surface to identify the centres of the four mounting holes.
6. Mark an outline for the cutout by using the dimensions H and W. Make sure the cutout is centred with respect to the mounting
holes.
7. Carefully drill the four mounting holes.
8. Carefully cut a rectangular cutout hole in the supporting surface according to the markings you made in step 6.
 Prepare the edges of the cutout to remove sharp edges and burrs.
efesotomasyon.com