Inovance MD500T75G - Page 35

MD500 User Manual 2. Mechanical Installation
- 35 -
Ƶ
Stage 3: Installing the Housing
10. Lift the housing into the cutout you have prepared.
Insert the housing from the correct side of the mounting surface, depending on whether you are using a front-mounting or a
rear-mounting arrangement.
WARNING
Always use a hoist to lift a sheet metal housing, and use help to support the
KRXVLQJLQLWVPRXQWLQJORFDWLRQXQWLO\RXKDYHÀ[HGLWLQSODFH
11. Insert the securing screws through the holds in the hanging brackets, and use them to secure the housing to the mounting
surface.
6HH)LJXUHDQG)LJXUHIRUH[DPSOHVWKDWVKRZKRZWRLQVWDOOWKH0'KRXVLQJ
Figure 2-8 Embedded installation of a plastic housing
Lift the housing into the prepared
cutout and secure it in position.
Embedded mounting of
the drive is completed.
3 4
Continued
from Figure 2-5
)LJXUH(PEHGGHGLQVWDOODWLRQRIDVKHHWPHWDOKRXVLQJ
Lift the housing into the prepared
cutout and secure it in position.
3
4
Continued
from Figure 2-7
Embedded mounting of
the drive is completed.
This completes the mechanical installation of an embedded MD500 housing. You can now follow the instructions in ## to complete
removal of the front cover of the MD500 before performing electrical installation.
Hanging Bracket Models
Hanging Bracket Model Adaptable AC Drive Model
MD500-AZJ-T5 MD500T18.5G
MD500T22G
MD500-AZJ-T6 MD500T30G
MD500T37G
MD500-AZJ-T7 MD500T45G
MD500T55G
MD500-AZJ-T8 MD500T75G
0'7*
MD500T110G
efesotomasyon.com