Commissioning and Trial Run
‑71‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
F0‑15 61455 Carrier frequency 0.8–15.0 kHz Model
dependent
kHz Modifiable
in any states
F0‑16 61456 Carrier frequency
adjusted with
temperature
0: No
1: Yes
1 ‑ Modifiable
in any states
F0‑17 61457 Acceleration time 1 0.0s to 6500.0s 20.0 s Modifiable
in any states
F0‑18 61458 Deceleration time 1 0.0s to 6500.0s 20.0 s Modifiable
in any states
F0‑19 61459 Acceleration/
Deceleration time unit
0: 1s
1: 0.1s
2: 0.01s
1 ‑ Modifiable
only at stop
F0‑21 61461 Frequency offset of
auxiliary frequency
reference when main
and auxiliary
frequency references
are superposed
0.00–655.35 Hz 0.00 Hz Modifiable
in any states
F0‑22 61462 Frequency reference
resolution
1: 0.1 Hz
2: 0.01 Hz
2 Hz Modifiable
only at stop
F0‑23 61463 Retention of digital
frequency at stop
0: Non‑retentive
1: Retentive
0 ‑ Modifiable
in any states
F0‑25 61465 Acceleration/
deceleration time
reference frequency
0: F0‑10 (Maximum
frequency)
1: Frequency reference
2: 100 Hz
0 ‑ Modifiable
only at stop
F0‑26 61466 Reference frequency
for UP/DOWN
modification during
running
0: Running frequency
1: Frequency reference
0 ‑ Modifiable
only at stop
F0‑27 61467 Main frequency
coefficient
0.00% to 100.00% 10.00 % Modifiable
in any states
F0‑28 61468 Auxiliary frequency
coefficient
0.00% to 100.00% 10.00 % Modifiable
in any states
F0‑29 61469 G/P model 1–2 1 ‑ Modifiable
only at stop
F1‑00 61696 Motor type selection 0: Common asynchronous
motor
1: Variable frequency
asynchronous motor
2: Synchronous motor
0 ‑ Modifiable
only at stop
F1‑01 61697 Rated motor power 0.1–1000.0 kW Model
dependent
kW Modifiable
only at stop
F1‑02 61698 Rated motor voltage 1–2000 V Model
dependent
V Modifiable
only at stop
To Next Page
Loading...
